ROTAX SOFT START MODULE – 6 PIN
Categorías: ROTAX ACCESSORIES AND SUPPLIES, Startes
Overview
| 13563 Rotax Soft Start Module – 6 pin Have you had any problems with your engine kicking back during start up? The Soft Start Module (SSM) alters the timing on one ignition circuit. The SSM is designed to keep the timing retarded until after the starting sequence has finished. By holding the timing retarded longer it has been found to be highly beneficial for smoother starts on 912ULS engines fitted with a slipper clutch. The real cause of these problems is often inadequate batteries and long starter cables resulting in slow cranking speeds. The Soft Start Module helps overcome the problems caused by these short falls. Features: Fully solid state. Fully automatic, the soft start module is triggered by each attempt to start the engine. 4 pin and 6 pin options available to accommodate the two different types of connectors found on the Rotax 912 & 914 series engines. Safety Features: Single Mag ignition circuit installation, leaving the other circuit to operate as normal. (Other circuit must be wired to be switched off during starting). Twin parallel circuits for added safety backup. Available with either a 6 way plug or 4 way plug configuration to fit the type used on your engine. In order to determine which plug configuration you need to order, you will need to locate the part number on the Rotax Electronic Module fitted to your engine (See 912 parts book) or be ready to supply engine serial number when ordering. |
