GROVE AXLE REALIGNMENT SHIMS
42.35$ + IVA
Overview
| Install these axle shims between your landing gear and axles to insure that your tires track true. Correct any misalignment of toe-in or toe-out in 1/4″ increments. |
Selection Guide
1. Support the aircraft in level flying attitude.
2. Chalkline the center-line of the aircraft onto the floor. Do this by connecting a mark on the floor from directly beneath the center of the firewall (use a plumb-bob) and from directly beneath the center of the tail (also using a plumb-bob). 3. Place a 36″ straight edge against the outside of the tire. It should be parallel with the floor and approximately centered on the wheel. 4. Make a mark on the floor directly beneath each end of the 36″ straight edge. Use a plumb-bob or square for this. 5. Measure and record distances D-1 and D-2. These are the distances between the marks in step 4 and the aircraft center-line. 6. Calculate Delta D, which is the difference between D-1 and D-2. Delta D changes by 0.157″ for each 1/4″. To Change Delta D by 0.10″ – 0.25″ Use 1/4″ Shim |
